Lincoln - MKT - Miscellaneous Documents - 2019 - 2019

2019 LINCOLN MKC TRAILER TOWING SELECTOR Required Equipment LINCOLN MKC (1) Engine Final Drive GCWR (lbs.) Ratio FWD AWD Turbocharged 2.0L I4 Turbocharged 2.3L I4 3.36 3.51 3.51 Maximum Loaded Trailer Weight (lbs.) Automatic Transmission 7,220 – – 7,400 – 7,420 (1) Calculated with SAE J2807 method. 3,000(2) 3,000(2) 3,000(2) Lincoln MKC (2) Requires Class II Trailer Tow Package. Note: Certain states require electric trailer brakes for trailers over a specified weight. Be sure to check state regulations for this specified weight. The maximum trailer weights listed above may be limited to this specified weight, as the electrical system does not include the wiring connector needed to activate electric trailer brakes. Trailer Towing Package Model (Option Code) Lincoln MKC (536) Vehicle Hitch Receiver X Lincoln MKC Trailer Sway Control X 110V/150W Power Outlet X Notes: • Content may vary depending on model, trim and/or powertrain. See your dealer for specific content information. • T railer Towing Package recommended for all vehicles that will be used for towing to help ensure easy, proper connection of trailer lights. Factory-Installed Trailer Hitch Receiver Options For trailers over 2,000 pounds – Class II Trailer Tow Package *Check with your dealer for additional requirements, restrictions and limited warranty details. Frontal Area Considerations X Trailer Wiring Harness (4-Pin) Includes items that must be installed.* Your New Vehicle Limited Warranty (see your dealer for a copy) may be voided if you tow without them. Frontal Area Limitations/ Considerations Base Vehicle Frontal Area (20 sq. ft.) 30 sq. ft. With Without Class II Trailer Tow Package With Class II Trailer Tow Package Frontal Area is the total area in square feet that a moving vehicle and trailer exposes to air resistance. The chart above shows the maximum trailer frontal area that must be considered for a vehicle/trailer combination. Exceeding these limitations may significantly reduce the performance of your towing vehicle. Hitch Receiver Weight Capacity Refer to the Trailer Towing Selector chart for Maximum Loaded Trailer Weights for this vehicle. Lincoln MKC: Included with Class II Trailer Tow Package – Option Code 536 Vehicle Note: S  ee chart at right for the weight-carrying capacity of this hitch receiver. (This capacity also is shown on a label affixed to each receiver.) (1) Hitch receivers do not include a hitch ball or ball mounting. You are responsible for obtaining the proper hitch ball, ball mounting, and other appropriate equipment to tow both the trailer and its cargo load. Lincoln MKC Weight-Carrying Max. Trailer Capacity (lbs.) (1) Max. Tongue Load (lbs.) 3,000 300 Preliminary 2019 Lincoln Trailer Towing information. Final version will be published September 2018. 2019 LINCOLN MKT Required Equipment TRAILER TOWING SELECTOR LINCOLN MKT Engine Twin-Turbocharged 3.5L V6 Axle Configuration Maximum Loaded Trailer Weight (lbs.) Automatic Transmission AWD 4,500(1) (1) Requires Class III Trailer Tow Package (53G). Note: MKT calculated with SAE J2807 method. Trailer Towing Package Model (Option Code) 2018 model shown. Includes items that must be installed.* Your New Vehicle Limited Warranty (see your dealer for a copy) may be voided if you tow without them. Lincoln MKT For trailers over 2,000 pounds – Class III Trailer Tow Package *Check with your dealer for additional requirements, restrictions and limited warranty details. Frontal Area Considerations Lincoln MKT (53G) 7-Wire Harness & 4-/7-Pin Connector X Hitch Receiver X Trailer Sway Control X Notes: • Content may vary depending on model, trim and/or powertrain. See your dealer for specific content information. • T railer Towing Package recommended for all vehicles that will be used for towing to help ensure easy, proper connection of trailer lights. Factory-Installed Trailer Hitch Receiver Options Lincoln MKT: Included with Class III Trailer Tow Package – Option Code 53G Note: S  ee chart at right for the weight-carrying and weightdistributing capacities of this hitch receiver. (This capacity also is shown on a label affixed to each receiver.) Frontal Area Limitations/ Considerations Vehicle Lincoln MKT With Base Vehicle Frontal Area (20 sq. ft.) Without Class III Trailer Tow Package 40 sq. ft. With Class III Trailer Tow Package Frontal Area is the total area in square feet that a moving vehicle and trailer exposes to air resistance. The chart above shows the maximum trailer frontal area that must be considered for a vehicle/trailer combination. Exceeding these limitations may significantly reduce the performance of your towing vehicle. Hitch Receiver Weight Capacity Refer to the Trailer Towing Selector chart for Maximum Loaded Trailer Weights for this vehicle. Vehicle Lincoln MKT Weight-Carrying Max. Trailer Capacity (lbs.) (1) Max. Tongue Load (lbs.) Weight-Distributing Max. Trailer Capacity (lbs.) (1) Max. Tongue Load (lbs.) 2,000 200 4,500 450 (1) Hitch receivers do not include a hitch ball or ball mounting. You are responsible for obtaining the proper hitch ball, ball mounting, weight-distributing equipment (i.e., equalizing arms and snap-up brackets, sway control system) and other appropriate equipment to tow both the trailer and its cargo load. Preliminary 2019 Lincoln Towing information. Final version will be published September 2018. KNOW BEFORE YOU TOW Before you buy BRAKES TRAILER LAMPS If you are selecting a vehicle that will be used for towing, you should determine the approximate weight of the trailer you intend to tow, including the weight of any additional cargo and fluids that you will be carrying in the trailer. Also, be sure the vehicle has the proper optional equipment. Keep in mind that performance can be severely compromised in hilly terrain when minimum acceptable powertrain combination is selected. Consider purchasing a vehicle with a more powerful engine. Many states require a separate braking system on trailers with a loaded weight of more than 1,500 pounds. For your safety, Ford Motor Company recommends that a separate functional brake system be used on any towed vehicle, including those dollytowed or towbar-towed. There are several basic types of brake systems designed to activate trailer brakes: 1. E  lectronically Controlled Brakes usually provide automatic and manual control of trailer brakes. They require that the tow vehicle be equipped with a controlling device and additional wiring for electrical power. These brakes typically have a control box installed within reach of the driver and can be applied manually or automatically. 2. E  lectric-Over-Hydraulic (EOH) Trailer Brakes are operated by an electrically powered pump that pressurizes a hydraulic fluid reservoir built into the trailer’s brake system. Many of the available EOH trailer brake models are compatible with the Ford factory installed, dash-integrated Trailer Brake Controller (TBC). 3. S  urge Brakes are independent hydraulic brakes activated by a master cylinder at the junction of the hitch and trailer tongue. They are not controlled by the hydraulic fluid in the tow vehicle’s brake system, and the tow vehicle’s hydraulic system should never be connected directly to the trailer’s hydraulic system. Be sure your trailer brakes conform to all applicable state regulations. See Towing Safely for All Vehicles on the next page for additional braking information. Make sure the trailer is equipped with lights that conform to all applicable government regulations. The trailer lighting system should not be connected directly to the lighting system of the vehicle. See a local recreational vehicle dealer or rental trailer agency for correct wiring and relays for the trailer and heavy-duty flashers. After you buy Before heading out on a trip, check your vehicle’s Owner’s Manual for break-in and severe-duty maintenance schedules (do not tow a trailer until your vehicle has been driven at least 1,000 miles). Be sure to have your fullyloaded vehicle (including passengers) and trailer weighed so as not to exceed critical weight limits. If any of these limits are exceeded, cargo should be removed from the vehicle and/or trailer until all weights are within the specified limits. SAFETY CHAINS – Always use safety chains when towing. Safety chains are used to retain connection between the towing and towed vehicle in the event of separation of the trailer coupling or ball – Use cross chains under the trailer tongue to prevent the tongue from contacting the ground if a separation occurs. Allow only enough slack to permit full turning – be sure they do not drag on the pavement – When using a frame-mounted trailer hitch, attach the safety chains to the framemounted hitch using the recommendations supplied by the hitch manufacturer – See your vehicle’s Owner’s Manual for safety chain attachment information – For rental trailers, follow rental agency instructions for hookup of safety chains TRAILER WIRING HARNESS – Some vehicles equipped with a factoryinstalled Trailer Tow Package include a trailer wiring harness and a wiring kit – This kit includes one or more jumper harnesses (to connect to your trailer wiring connector) and installation instructions Preliminary 2019 Lincoln Trailer Towing information. Final version will be published September 2018. TOWING SAFELY FOR ALL VEHICLES Towing a trailer is demanding on your vehicle, your trailer and your personal driving skills. Follow some basic rules that will help you tow safely and have a lot more fun. Weight Distribution – For optimum handling and braking, the load must be properly distributed – Keep center of gravity low for best handling – Approximately 60% of the allowable cargo weight should be in the front half of the trailer and 40% in the rear (within limits of tongue load or king pin weight) – Load should be balanced from side-to-side to optimize handling and tire wear – Load must be firmly secured to prevent shifting during cornering or braking, which could result in a sudden loss of control Before Starting – Before setting out on a trip, practice turning, stopping and backing up your trailer in an area away from heavy traffic – Know clearance required for trailer roof – Check equipment (make a checklist) Backing Up – Back up slowly, with someone spotting near the rear of the trailer to guide you – Place one hand at bottom of steering wheel and move it in the direction you want the trailer to go – Make small steering inputs—slight movement of steering wheel results in much greater movement in rear of trailer Turning When turning, be sure to swing wide enough to allow trailer to avoid curbs and other obstructions. Braking – Allow considerably more distance for stopping with trailer attached – Remember, the braking system of the tow vehicle is rated for operation at the GVWR, not GCWR – If your tow vehicle is a F-150, F-Series Super Duty®, Transit or Expedition and your trailer has electric brakes, the optional Integrated Trailer Brake Controller (TBC) assists in smooth and effective trailer braking by powering the trailer’s electric or electric-over-hydraulic brakes with proportional output based on the towing vehicle’s brake pressure – If your trailer starts to sway, apply brake pedal gradually. The sliding lever on the TBC should be used only for manual activation of trailer brakes when adjusting the gain. Misuse, such as application during trailer sway, could cause instability of trailer and/or tow vehicle Towing On Hills – Downshift the transmission to assist braking on steep downgrades and to increase power (reduce lugging) when climbing hills – With TorqShift ® transmission, select tow/haul mode to automatically eliminate unwanted gear search when going uphill and help control vehicle speed when going downhill Parking With A Trailer Whenever possible, vehicles with trailers should not be parked on a grade. However, if it is necessary, place wheel chocks under the trailer’s wheels, following the instructions below. – Apply the foot service brakes and hold – Have another person place the wheel chocks under the trailer wheels on the downgrade side – Once the chocks are in place, release brake pedal, making sure the chocks will hold the vehicle and trailer – Apply the parking brake – Shift automatic transmission into park, or manual transmission into reverse – With 4-wheel drive, make sure the transfer case is not in neutral (if applicable) Starting Out Parked On A Grade – Apply the foot service brake and hold – Start the engine with transmission in park (automatic) or neutral (manual) – Shift the transmission into gear and release the parking brake – Release the brake pedal and move the vehicle uphill to free the chocks – Apply the brake pedal while another person retrieves the chocks Acceleration And Passing The added weight of the trailer can dramatically decrease the acceleration of the towing vehicle – exercise caution. – When passing a slower vehicle, be sure to allow extra distance. Remember, the added length of the trailer must clear the other vehicle before you can pull back in – Signal and make your pass on level terrain with plenty of clearance – If necessary, downshift for improved acceleration Driving With An Automatic Overdrive Transmission With certain automatic overdrive transmissions, towing—especially in hilly areas—may cause excessive shifting between overdrive and the next lower gear. – To eliminate this condition and achieve steadier performance, overdrive can be locked out (see vehicle Owner’s Manual) – If excessive shifting does not occur, use overdrive to optimize fuel economy – Overdrive may also be locked out to obtain engine braking on downgrades – When available, select tow/haul mode to automatically eliminate unwanted gear search and help control vehicle speed when going downhill Driving With Cruise Control Turn off the cruise control with heavy loads or in hilly terrain. The cruise control may turn off automatically when you are towing on long, steep grades. Use caution while driving on wet roads and avoid using cruise control in rainy or winter weather conditions. Tire Pressure – Underinflated tires get hot and may fail, leading to possible loss of vehicle control – Overinflated tires may wear unevenly and compromise traction and stopping capability – Tires should be checked often for conformance to recommended cold inflation pressures Spare Tire Use A conventional, identical full-size spare tire is required for trailer towing (mini, compact and dissimilar full-size spare tires should not be used; always replace the spare tire with a new road tire as soon as possible). On The Road After about 50 miles, stop in a protected location and double-check: – Trailer hitch attachment – Lights and electrical connections – Trailer wheel lug nuts for tightness – Engine oil—check regularly throughout trip High Altitude Operation Gasoline engines lose power by 3-4% per 1,000 ft. elevation. To maintain performance, reduce GVWs and GCWs by 2% per 1,000 ft. elevation starting at the 1,000 ft. elevation point. Powertrain/Frontal Area Considerations The charts in this Guide show the minimum engine size needed to move the GCW of tow vehicle and trailer. – Under certain conditions, however, (e.g., when the trailer has a large frontal area that adds substantial air drag or when trailering in hilly or mountainous terrain) it is wise to choose a larger engine – Selecting a trailer with a low-drag, rounded front design will help optimize performance and fuel economy Note: For additional trailering information pertaining to your vehicle, refer to the vehicle Owner’s Manual. For the latest RV/Towing information, check out www.fleet.ford.com/towingguides or for Lincoln Dealers go to lincoln. productportfolio.dealerconnection.com. Photography, illustrations and information presented herein were correct when approved for publishing. Ford Motor Company reserves the right to discontinue or change at any time the specifications or designs without incurring obligation. Some features shown or described are optional at extra cost. Some options are required in combination with other options. Consult your dealer for the latest, most complete information on models, features, prices and availability. Many of the recreational vehicles shown in this brochure are modified or manufactured by companies other than Ford Motor Company. Ford assumes no responsibility for such modifications or manufacturing. Preliminary 2019 Lincoln Trailer Towing information. Final version will be published September 2018.