Honda - HR-V S - Owners Manual - 2016 - 2016

Installation instructions for part 95-7810B Table of Contents Honda HR-V 2016-up 95-7810B Dash Disassembly.................................................. 2 Kit Assembly –. ISO DDIN radio provision....................................... 3 KIT FEATURES • ISO DDIN radio provision • Painted matte black REV. 12/10/2015 INST95-7810B KIT COMPONENTS • A) Radio trim panel • B) Radio trim panel brackets • C) Rear support bracket • D (8) #6 x 3/8” Phillips screws A B C D CAUTION: Metra recommends disconnecting the negative battery terminal before beginning any installation, unless the vehicle manufacturer recommends against so. Please check with your local Dealership for more information. All accessories, switches, climate controls panels, and especially air bag indicator lights must be connected before reconnecting the battery or cycling the ignition. Also, do not remove the factory radio with the key in the on position, or the vehicle running. It would be best to remove the key from the ignition and then wait a few seconds before removing the factory radio. WIRING & ANTENNA CONNECTIONS (sold separately) Wiring Harness: • 70-1729 Antenna Adapter: • 40-HD11 METRA. The World’s best kits.™ TOOLS REQUIRED • Panel removal tool • Phillips screwdriver • 8 mm socket wrench metraonline.com © COPYRIGHT 2015 METRA ELECTRONICS CORPORATION 95-7810B Dash Disassembly 1. Open the glove box door. 2. Unclip and remove the trim panel surrounding the radio and a/c vent located to the left of the radio. (Figure A) 3. Remove (2) Phillips screws and (1) 8mm screw securing the factory radio, and then unplug and remove the radio. (Figure B) Continue to kit assembly (Figure A) (Figure B) 2 95-7810B Kit Assembly 1. Attach the radio trim panel brackets to the radio trim panel using (4) #6 x 3/8” Phillips screws supplied. (Figure A) 4. Locate the factory wiring harness and antenna connector in the dash, and complete all necessary connections to the radio. Metra recommends using the proper mating adapter from Metra and/or AXXESS. Re-connect the negative battery terminal and test the radio for proper operation. 2. Attach the rear support bracket to the radio trim panel brackets using (4) #6 x 3/8” Phillips screws supplied. (Figure B) 3. Slide the radio into the completed assembly, and then secure it to the assembly using the screws supplied with the radio. (Figure C) 5. Reassemble the dash in reverse order of disassembly. (Figure A) (Figure C) (Figure B) 3 Installation instructions for part 99-7810B IMPORTANT If you are having difficulties with the installation of this product, please call our Tech Support line at 1-800-253-TECH. Before doing so, look over the instructions a second time, and make sure the installation was performed exactly as the instructions are stated. Please have the vehicle apart and ready to perform troubleshooting steps before calling. KNOWLEDGE IS POWER REV. 12/10/2015 INST95-7810B Enhance your installation and fabrication skills by enrolling in the most recognized and respected mobile electronics school in our industry. Log onto www.installerinstitute.com or call 800-354-6782 for more information and take steps toward a better tomorrow. Metra recommends MECP certified technicians METRA. The World’s best kits.™ metraonline.com © COPYRIGHT 2015 METRA ELECTRONICS CORPORATION