BMW - X6 Sports - Workshop Manual - 2022 - 2022

SIB 11 05 21 SERVICE ACTION: REPLACE THE MECHANICAL COOLANT PUMP 2022-04-11 This Service Information Bulletin (Revision 3) replaces SI B11 05 21 dated April 2022. What’s New (Specific text highlighted): Sublet for coolant is updated Please perform the procedure outlined in this Service Information on all affected vehicles before customer delivery. In the event the customer has already taken delivery of the vehicle, please perform the procedure the next time the vehicle is in the shop. MODEL G05 (X5 Sports Activity Vehicle) G22 (4 Series Coupe) G06 (X6 Sports Activity Coupe) G23 (4 Series Convertible) G07 (X7 Sports Activity Vehicle) G20 (3 Series Sedan) G30 (5 Series Sedan) AFFECTED VEHICLES This Service Action involves G05, G06, G07, G20, G22, G23 and G30 vehicles produced from September 2020 to May 24, 2021. Vehicles which require this Service Action to be completed will show it as “Open” when checked either in AIR, the "Service Menu" of DCSnet (Dealer Communication System) or with the Key Reader. SITUATION The belt pulley on the mechanical coolant pump may fracture allowing the engine drive belt to come off the coolant pump and alternator. CORRECTION Replace the coolant pump PROCEDURE Follow Repair Instruction 11 51 000 Removing and installing/replacing the coolant pump. NOTE: The bolt hole for the coolant flange (1) may not be threaded. The self-tapping screw from the original water pump must be re-used. Follow this tightening sequence (threads or no threads present) 1. Tighten to 12.5 Nm 2. Loosen the screw 360 degrees (one full turn) 3. Tighten the screw again to 12.5 Nm PARTS INFORMATION Please monitor the Parts Matrix for ordering information. Only use and invoice the part numbers when applicable. Performing a part number look-up in ETK (EPC) by VIN or model in place of using/invoicing the following part numbers may result with the wrong part numbers being invoiced and installed, this could delay the payment of the claim. Part Number 11 51 5 A44 4F4 Description Coolant pump (48V mild hybrid technology) Quantity 1 Copyright ©2022 BMW of North America, Inc. 11 51 8 482 260 O-ring 11 53 8 674 931 O-ring (28.7x2.5) 11 53 8 678 045 Seal (29.8x4.6x2.2) 11 11 8 664 905* Shaft seal (55x68x8) 83 19 2 468 442 Coolant *TC Approval not required 1 1 1 1 As needed Other small parts such as screws, nuts and seals, which must be replaced according to the ISTA repair instructions, must be selected from the Electronic Parts Catalogue according to the respective vehicle type and invoiced under the special defect code. CLAIMS INFORMATION Reimbursement for this Service Action will be via normal claim entry utilizing the applicable work package information below, and when required, the part numbers listed above. Note: For the Main and Plus repair-related labor operation codes below, the Flat Rate Units search in AIR will show two (2) available Flat Rate Unit groups with different overall FRU allowances. Both are based on the same Main repair labor code. The Flat rate unit group with the higher overall FRU allowances applies to 48 Volt equipped vehicles, the other group with the lower overall FRU allowances applies to non-48 Volt equipped vehicles. Select the Main or Plus repair flat rate labor operation code with the FRU allowance from the Flat Rate Unit group that applies to the vehicle being repaired. Defect Code: 0011160600 G0x G2x G3x B58C B58D Replacing coolant pump Completion before the first vehicle delivery to a customer or the vehicle is already in the workshop Work Pkg Labor Operation Description (Plus work) Labor Allowance #1 00 70 985 Replacing the coolant pump Refer to the AIR #2 00 70 986 Replacing the coolant pump and deleting fault memory (Vehicle test) (CC message already present) Refer to the AIR Or: --- --- --- #3 00 70 987 Vehicle was already taken care of through another repair or Technical Campaign 1 FRU Or: *Please refer to the attachment for the applicable FRU allowances until these repair times show in AIR. Or: The vehicle arrives at your center and this Service Action shows open (No other Main work will be performed or claimed during this workshop visit) Work Pkg Labor Operation Description (Main work) Labor Allowance #4 00 70 425 Replacing the coolant pump Refer to the AIR #5 00 70 426 Replacing the coolant pump and deleting fault memory (Vehicle test) (CC message already present) Refer to the AIR Or: --- --- --- #6 00 70 427 Vehicle was already taken care of through another repair or Technical 1 FRU Or: Copyright ©2022 BMW of North America, Inc. Campaign Only one of the flat rate labor operation codes listed above can be used for claim submission and reimbursement. Also, only one Main work flat rate labor operation code can be claimed per workshop visit. Claim Repair Comments Only reference the SIB number and the work package (Pkg) number performed in the RO technician notes and the claim comments (For example: B11 05 21 WP 1), unless otherwise required by State law. If additional work was required due to this issue, explain the why and what on the repair order and in the claim comments And, as needed: Sublet – Bulk Materials (RO and Claim Comments Required) Sublet Code 4 Up to $150.00 Reimbursement for the repair-related bulk material (Do not use the BMW part number for claim submission) Sublet reimbursement calculation for claiming the applicable repair-related bulk material (BMW part numbers) is at the dealer net price amount for the quantity used plus your center’s handling. BMW Antifreeze/Coolant: Claim the corresponding sublet dollar amount for the quantity needed to replace what was drained with a 50/50 coolant/water solution. Enter this material cost in sublet and itemize the amount on the repair order and in claim comment section. Alternative Mobility Solution (AMS) for Vehicle Owners (RO and Claim Comments Required) This Service Action repair qualifies for Alternative Mobility Solution (AMS) expense reimbursement, claim this item under the Defect Code noted above as follows: Sublet Code 2 - Itemize the AMS sublet amount on the repair order and in the claim comment section. Please refer to SI B01 29 16 for additional information. QUESTIONS REGARDING THIS BULLETIN Technical inquiries Warranty inquiries Parts inquiries Submit feedback at the top of this bulletin Please contact the Warranty department by either using the Live Chat that’s available in the Warranty Documentation Portal or through IDS by selecting Coverage, Policy, Coding Questions and Mileage Corrections Submit an IDS ticket to the Parts Department Supporting Materials Copyright ©2022 BMW of North America, Inc.